Pcnautic Autopilot
English
English
  • Introduction
  • Disclaimer
  • Content Pcnautic Autopilot set
  • Quick Start Guide
  • Installation
    • TillerDrive
    • MotorController
    • Controlhead
  • Operate
    • ControlHead
    • Web Interface
      • Control
      • Profiles
      • Tuning
      • Configuration
      • Compass Calibration
      • Rudder Calibration
      • Wifi / network config
      • Maintenance
        • Emergency
      • Statistics
    • Monitoring and Alarming
    • Wear OS smartwatch app
    • OpenCPN Plug in
  • Calibration and Configuration
  • Firmware update
  • NMEA data connections (TCP / USB)
    • B&G
    • OpenCPN
    • Simrad
    • YachtDevices YDWG
    • TCP NMEA Data Connection with Autopilot as NMEA Data Client
  • Specifications
  • Maintenance
  • Troubleshooting
Powered by GitBook
On this page

Was this helpful?

  1. Installation

TillerDrive

PreviousInstallationNextMotorController

Last updated 2 months ago

Was this helpful?

After your order, we ask regarding the installation.

The set is fully tested and delivered plug & play. We recommend reviewing the beforehand for a smooth start.

Midstroke

After your order, we will for your desired midstroke length.

The standard midstroke is 620 mm. If you require a different size, please specify your preferred midstroke.

The midstroke is the distance between the tiller pin and the brass bushing, measured with the rudder in the center position.

  • Minimum midstroke: 600 mm

  • Maximum midstroke: 900 mm

The set is fully tested and delivered plug & play — the connectors are already pre-installed for you!

Pin configuration of the TillerDrive connector:

Quick Start Guide
seven questions
Please read these questions carefully first!
ask