FAQ / Frequently Asked Questions
Below you’ll find answers to common questions we receive about the Pcnautic Autopilot:
Last updated
Was this helpful?
Below you’ll find answers to common questions we receive about the Pcnautic Autopilot:
Last updated
Was this helpful?
First, try updating the firmware again following the . If it still doesn’t work, use the special page to perform the update.
Click for instructions to reset the WiFi settings to factory defaults using the Controlhead.
Click for instructions to reset the WiFi settings to factory defaults using the Controlhead.
Go to WiFi on the Controlhead.
Press M.
The IP address is shown at the bottom (default: 192.168.14.1).
If you’ve set a manual IP address, it will not appear in the list of DHCP leases. The list only shows automatically assigned (DHCP) IP addresses.
This log displays error messages from the motor controller, such as:
Excessive current
Servo out of range
Other hardware-related errors
When the option "Servo min/max rudder fault beep active" is enabled, a warning signal sounds if the servo moves outside its allowed range.
If you are unable to connect to the web interface (via browser or Android app) while being connected to the Autopilot via WiFi, try disabling mobile data.
When you connect your phone to the Autopilot via WiFi (in Master (AP) mode), most phones will lose internet access over 4G or 5G. A solution for this can be found under .
Can’t solve the issue using this FAQ? Please send an email to with a clear description of the problem. Also include log files, which you can download via the page.