B&G

Connecting the Autopilot to the B&G Plotter via Wi-Fi

Step 1: Connect the Autopilot to the B&G Wi-Fi Network

  1. Open the web interface in your browser.

  2. Go to the Wifi / network config page.

  3. Under Wifi Mode, select 'Managed (client)' .

  4. Enter the SSID (network name) and password of your B&G plotter’s Wifi network.

  5. (Optional) You may enter a static IP address, but it is recommended to leave this blank and use DHCP instead for automatic configuration.

  6. Click Submit to apply the changes and initiate the connection.

    • The Autopilot will now attempt to join the plotter's Wifi network.

Step 2: Configure the Autopilot as a NMEA 0183 Data Client

  1. This can be done onn the same Wifi / network config page

  2. In the IP Address field, enter the IP address of the B&G plotter (typically 192.168.76.1).

  3. In the Port Number field, enter 10110.

  4. Click Submit to save the settings.

The Autopilot will now make a TCP-connection to the B&G plotter and begin receiving NMEA 0183 data (such as GPS, wind, and AIS information) over Wifi.

Last updated

Was this helpful?